Using a circular saw can be a challenging task, especially if you are using it for the first time. It is an efficient and fast tool that needs to be handled carefully. In the beginning, it may feel overwhelming. But with the right tips and tricks, you will be good to go. To help you out, we have laid down some saw cutting guide tips following which you can get the perfect cuts. If you think you need help, then you should give this article a read.

Tips For Saw Guide

If you know the right techniques to use a circular saw guide, you can accomplish any task with ease. Here are some tips that you may find helpful.

Avoid Setting the Blade Too Deep

When using a circular saw, you need to maintain the proper depth. This is where most people go wrong. Setting the blade too deep can cause problems. Not just that, but it is also risky to handle your saw like that. This is why you need to expose the blade properly while cutting the board. When you set the blade too deep, it tends to kickback. But by setting it right, you can cut your wood more efficiently.

Let the Cut-off Fall Freely

You should always let the cut-off piece of wood fall freely. However, you should be careful that the cut piece can take a sliver of wood with it. In this case, your project may get ruined. To prevent this from happening, you should provide support to the board continuously.

However, you should not use a clamp, or else the cut piece will not move away freely.

Don’t Support Wood on Both Ends

This is a common mistake made by many users. Cutting a wood that is supported from both ends is like cutting a tree limb. There is a 98% chance that it will turn out to be a disaster. When you are about to finish the cut, the wood will bow downward.

This, as a result, will pinch the blade in the cut, and the board or the saw will buck. This will not only ruin your project but is also quite risky for you. Not to mention, it will make things messy.

For Rip Cuts, Secure the Board

If you are going for rip cuts, then using a table saw would be a better option. However, if you want to stick to using a circular saw, then you need to secure your board right. However, you should know that you may not get a fine cut with a circular saw.

You need to hold the wooden board in place while making a rip cut. In case the board you are about to cut is very wide, then you can clamps. As an alternative measure, you can also tack the wooden board to your sawhorses. We would suggest you use quality nails so that it doesn’t damage the board while pulling them out.

Don’t Let the Saw Wander From the Line

You need to be skilled enough to make a straight line cut. This type of cuts needs practice. For those who are doing it for the first time may find it hard to accomplish. You have to make sure that your saw is aligned and you cut along the line.

However, if you make a mistake in the beginning, you won’t be able to align your blade back to the line. In this case, you should stop cutting and start again. This is a better thing to do than to steer the saw back onto the line. If you want to get the perfect starlight line cut, then you need to practice it.

Using a circular saw guide can be tricky, but with practice and few expert tips, you should be good to go. Make sure you keep these pointers in mind while working on your project.